Just one of my cool projects I had back in 2013, that's when this cool retro designed computer workstation was built by me.

Unfortunately, I had to move to a smaller unit with not much room and now have to sell it, [see my other listings on T.M] It's been used daily so expect maybe a few small defects it's had over time, main issues are, are the three Formica splits you see in fotos in 12 & 13. this happened in shifting which I hate, the workstation comes in two parts, the top part lifts off and the bottom part [main desk] all unscrews part for easy freighting as it is big. the top part stays intact.

FOTOS 1, 2, 3 As it was back in 2013, these are the finished fotos of it, FOTO 4, Shows the back lit light so you can see where to plug things up, handy in poor light. FOTOS 5 to 14 show the main desk itself, in foto 11 is a nice big deep slide out draw with lots of space, plus holes to feed computer wiring & cables. FOTO 10 shows lower shelf to put folders or other things on, FOTOS 8 & 9 show the two power boxes and a row of control switches which work the power boxes and back lit light. FOTOS 15 to 20 show the top part with a lock up cupboard with key and slide doors to a cupboard space to put things in. FOTOS 18 & 20 show the backing board I recycled from a old bed head board which is a bit sun damaged, I was going to respray it but left it original.

The whole desk is made of 18mm thick solid pine timber, no MDF crap here. even the chrome "V" retro handles are real.

Sizes; Top part; 1.540mm Wide x 800mm High x 375mm Deep Sizes; Main desk; 1.540mm Wide x 850mm [865mm on casters] High x 665mm Deep Over all height; 1.650mm Full height it has roller casters too so you can move it around.

LAST CHANCE AT $225, WAS $250, as is where is.

KEYWORDS, RETRO, RECYCLE, REUSE, see my listing for the FUTURISTIC SKYTOWER LAMP