A 1911 Belliss and Morcom vertical steam engine. I bought in Christchurch and was told it worked a winch. It was not a generator engine on a cast base. It stands about 5 foot 10 inches high from the base to the top pipe and is a compound steam engine. It's free, but has a good thick grease on it's rods to stop rust.

I had it dated: November 1911
Serial No: 4978
Class: C25
BHP: 36
RPM: 500
PSI Non Condensing: 150
Drive: Pulley
Flywheel diameter: 3 foot 3 inches.
Flywheel width: 4 1/2 inches.
Full Overall Height from the botton of the flywheel to the top pipe is: 6 foot 8 inches.
From bottom of the crankcase to the bottom of the flywheel is: 6 1/2 inches.
Overall Width is: 39 inches.
Cylinder size: 10 inches diameter.
Cylinder size: 6 inches diameter.
Stroke: 5 inches.
Valve Cylinder size: 5 1/2 inches diameter.

It's a heavy engine and will needed to be picked up.

The Canadian steam water pump, next to the Belliss and Morcom SE is not included in this auction.