A single to 3 phase VFD inverter will give you a much broader selection of motors to choose from when powering your project. This VFD will allow you to use virtually all 3phase motors with 220-240 Voltage, 2 to 12 poles.

Excellent for use on Lathes, Mills, Drilling machines and other industrial uses (water pump, fans, air compressors, conveyors etc). Can be used to control high speed Router Spindles (24000RPM +). It features a plethora of control options, from internal Timed Speed/Duration cycles to external Switches and Potentiometer, or automatic control and RS485.

Some features include:

> Frequency Up to 1200hz > For 220-240v Motors > Excellent protections (over current/ over voltage etc) > 0-5V, 0-10V, 4-20mA, analog signal control. > Adjustable carrier frequency. > External control > Tested to EN61800-3 standard & C-Ticked for approved NZ Use.

Check your Motor for 2 different operating voltages - it needs to have the option of a 220-240volt winding (commonly Delta wiring). These will operated 400v motors at lower RPM.

A wired remote control panel is available for $60 extra. The VFD is the is black one on the right.

Excellent quality (made in Taiwan)

12 MONTH WARRANTY

NOTE: These cannot be used to power anything other than one motor. Not suitable for multiple motors or general 3 phase power (welders and other 3 phase appliances etc).