This electric hoist can be bolted to an overhead beam, pipe or box section to make short work of any lifting jobs you have around the workshop. It can also be used as a winch for pulling loads. Just plug it in to an ordinary power point and away you go.

It is powered winding in, and powered winding out, at no time will it freewheel. The mechanical safety brake is only released when power is applied by the control switch, making it safe in the event of a power failure.

SINGLE LIFT - The hook hangs from the hoist by a single cable. DOUBLE LIFT - The hook hangs from the hoist by a double cable. The hook is attached to the body of the hoist to create a loop. The loop is put through the included pulley hook and the load is attached to the same hook. The leverage the pulley creates halves the lifting speed and doubles the lifting capacity.

Every hoist includes the double lift pulley hook.

FEATURES Forward and reverse control switch Control switch emergency button Load hook safety clips Fully wound in cut-out switch Hook ballast for easy unwinding Mounting brackets included Fail-safe mechanical safety brake Can be mounted in any position Controller cable length 1.5m

SPECIFICATIONS Cable diameter: 6.0mm Cable length: 12m Breaking strain: >3000kgs Mounting points: 280 x 110mm Clamps fit O.D: 60mm Motor rating: 230VAC 1800W Body size (LWH mm): 490 x 172 x 250 Weight: 32kgs

12 Months Warranty

When using with an extension lead it must meet the minimum specs. Extension lead up to 20m - 1.6mm2 minimum Extension lead 20 to 50m - 2.5mm2 minimum

Does not include the Electric Hoist Swing Arm, see our other products for that item.

IT ADDS UP TO CHOOSE TESTNTOOLS

• Friendly service, fast delivery
• GST invoice always supplied
• See our profile for the good stuff
• Check our feedback, we look after you!

Testntools is now on Facebook! "Like" us to be in on promo’s, special offers and new products