505XPR10LP240v Single Phase 2 Post with Low Pro Arms BendPak Hoists designed in the USA for the world market Used & Recommended by J.Leno, Boyd Coddington, Gas Monkey Garage, West Coast Customs, etc The BendPak XPR-10LP is the super-industrial-strength piece of equipment that has it all: leading-edge technology, top of the line materials, design that’s way ahead of its time and a 4.5-ton lifting capacity. Fits in shops with ceilings higher than 3.865 meters. All of the extended height models in our XPR-Series can easily lift some of your largest full-sized pickups and commercial vehicles (including Sprinters), yet still provide specific capability for sport and compact cars, both foreign and domestic. Direct-Drive two-post car lift technology BendPak two-post lifts feature low-pressure HVLP direct-drive cylinders eliminating the need for lifting chains or screw mechanisms most commonly found on other lift designs. Dual HVLP low-pressure cylinders minimize leakage and offer better reliability, smoother operation and less maintenance costs throughout the life of your lift. High-volume, low-pressure equates to less workload placed on the entire hydraulic system. Direct-Drive technology is preferred on commercial-grade two post car lifts as it has it has fewer moving parts than a chain-over-roller cylinder configuration. Pressurized hydraulic fluid flows from the power-unit, through the hollow cylinder rods then enters the cylinder body and fills the inside cavity. The pressure of the hydraulic fluid extends the piston rod downward raising the cylinder body and lift carriages. A dual-synchro equalization system maintains equal lifting and provides operators with a stable, level vehicle working condition.