This listing closed and did not sell.

CNC - 4 -axis Stepper Motor Controller and Driver Brand new item

  • No reserve No reserve 
  • Closed: Tue 22 Nov 2011, 8:45 am
Listing #: 423929070
4 axis Stepper driver and breakout board combined in one

* Uses Toshiba TB6560AHQ driver chip - maximum 3.5A drive current
* 1 - 1/16 microstep setting - higher accuracy, smoother operation
* Overload & over-current & over-temperature protection, full protection of your computer and peripheral equipment
* 4 current settings can be set according to the user the actual current requirement
* Full closed-type optical isolation to protect the user's computer and equipment
* Professional design, two-stage signal processing, super anti-jamming
* Bipolar constant current chopper drive motor low-speed non-creeping phenomenon, noise, non-resonant region
* Four input control, you can set limit switches and/or emergency stops.
* Power Supply required 12-36 V, 8A
* The interface of driver shall be connected with 2/4 phase, 4/6/8 leads stepper motor within 3A current
* This board can work with both unipolar and bipolar stepper motors
* The spindle motor can be controlled by Parallel Interface. (relay required)
* Manual included
* Manual shows exactly how to set up with Mach3
* Parallel Cable included

* Note: 3-axis model pictured, this auction is for 4-axis which is the same format.

See my other auctions for more lathe and mill accessories including other CNC equipment

TAX Invoice included with every order


Shipping details

  • $8.00  Tracked Courier to Non urban addresses
  • $6.00  Tracked Courier to urban addresses
  • $6.00  NZ post
  • $10.00  Australia (approx - please ask)
  • Seller does not allow pick-ups
  • Seller location: Amberley, Canterbury, NZ

Payment details

  • NZ bank deposit
  • Cash
  • Bank Deposit

About the seller

jwhyte (3053 3053 positive feedback) Address Verified May 2013 Member is In Trade
  • 99.9% positive feedback
  • Member since Sep 2004

Closes: Tue 22 Nov, 8:45 am. 2011