Kingston 8GB (1x8GB) DDR31600MHz CL11 1.5V DIMM ECC Registered ValueRAM Single Stick Intel ValidatedKingston Value RAM 8GB 1600MHz DDR3 ECC Registered CL11 DIMM SR x 4 with TS Intel Desktop Memory KVR16R11S4/8I

DESCRIPTION This document describes ValueRAM's 1G x 72-bit (8GB) DDR3- 1600 CL11 SDRAM (Synchronous DRAM), registered w/parity, 1Rx4 ECC, IntelA‚® Compatibility Tested, memory module, based on eighteen 1G x 4-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:

FEATURES JEDEC standard 1.5V (1.425V ~1.575V) Power Supply VDDQ = 1.5V (1.425V ~ 1.575V) 800MHz fCK for 1600Mb/sec/pin 8 independent internal bank Programmable CAS Latency: 11, 10, 9, 8, 7, 6 Programmable Additive Latency: 0, CL - 2, or CL - 1 clock 8-bit pre-fetch Burst Length: 8 (Interleave without any limit, sequential with starting address A?€L“000A?€Ât only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] Bi-directional Differential Data Strobe Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm A‚± 1%) On Die Termination using ODT pin On-DIMM thermal sensor (Grade B) Average Refresh Period 7.8us at lower than TCASE 85A‚°C, 3.9us at 85A‚°C < TCASE < 95A‚°C Asynchronous Reset PCB : Height 1.180A?€Ât (30.00mm), double sided component CL(IDD) 11 cycles Row Cycle Time (tRCmin) 48.125ns (min.) Refresh to Active/Refresh Command Time (tRFCmin) 260ns (min.) Row Active Time (tRASmin) 35ns (min.) Maximum Operating Power 5.196 W* UL Rating 94 V - 0 Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C Note *Power will vary depending on the SDRAM used.