Since 1997, Seahorse has designed and manufactured protective equipment cases that are watertight, airtight, and crush resistant. Located in Southern California, the Seahorse facility has been engineering, developing, manufacturing and testing products that are rugged and lightweight.

DIMENSIONS AND WEIGHTS Outside: 22.1cm x 19.05cm x 9.91cm Inside: 19.25cm x 12.9cm x 8.2cm Weight: 0.70 kg with foam and 0.66kg Empty Shipping Weight: 0.91kg

FEATURES: Watertight, Airtight, and Crush Resistant

Automatic Pressure Purge System: Seahorse's Automatic Pressure Purge System guarantees a perfect seal by incorporating its own O-Ring under one of the latches. You will never forget to set the valve since it automatically activates when closing the case. Pressure is released as you open the latch.

Molded-In Padlock Holes: Each case has two molded-in padlock holes to secure your valuables. The padlock holes will accept "TSA" and most standard padlocks.

Accuform Foam: Optional multilayer protective pre-scored cubed foam. Accuform Foam in Seahorse cases consists of a layer of egg crate foam in the lid, a thick cubed foam center, and a 1/2" thick high density shock absorbing foam bottom layer.

Waterproof Panel Kit: The Seahorse Panel Kits are used when specific equipment needs to be kept protected even when the case is open. These two plates are made of .063" brushed aluminum and include screws, one perimeter gasket and O-Rings for the screws to waterproof the bottom portion of your case.

Metal locks are made entirely of chromed steel and keyed.

Plastics locks are molded of ABS Resin, one of the toughest co-polymers available. Keys are also made of Plastic.

Made in the U.S.A.

Lifetime Guarantee*: SEAHORSE CASES are guaranteed against defects in materials and craftsmanship for the life of the case. Cases that have been modified are not covered by this guarantee.

See our shipping policies here: http://www.trademe.co.nz/stores/gearshop/shipping