12 MONTHS INTEREST FREE AVAILABLE

The New Zealand made SGM (Studio Grade Monitor) 380F, is one of the top speakers in our range.

This speaker uses a transmission line design, giving you a low and even bass response.

The cabinet is constructed from 18mm plywood, the finest material available to make speaker boxes out of.

The soft dome tweeter is replaced by a high end German tweeter which sounds silky smooth.

The speakers have been wired using Silver Plated Oxygen Free Copper PTFE coated cable.

The entire crossover is hand crafted and point-to-point wired, no circuit board track to be found anywhere. Although expensive and time consuming, this is the best way to construct a crossover. Polypropylene capacitors are used in place of standard electrolytic capacitors, one of the two weakest links in any crossover.

Polypropylene capacitors are usually not used extensively due to their cost (30x more than bipolar electrolytic capacitors). However when they are used they give an open, detailed and transparent sound with smooth high frequencies.

High quality chokes (inductors) are also used.

A high frequency filter is used to filter out unwanted RF noise.

A diffraction circuit is also used in the SGM380. A diffraction is when frequencies (usually 1KHz and above), small enough to fit on the front baffle (front of the speaker) therefore gaining 6dB in loudness.

Specifications:

• Frequency Response: 35Hz (at -2db) - 20KHz (at +/-3db)
• Power Rating: 90 Watts RMS (CONTINUOUS)
• Sensitivity: 89db (per 1 meter per Watt)
• Woofer: 8" treated paper cone
• Midrange: 5" treated paper cone
• Tweeter: Silk Dome
• Construction: 18mm Plywood with solid wood edging (your choice of finish)
• Feet: Gold Plated Speaker Stands
• Wiring: PTFE Coated Silver Plated Oxygen Free Copper cable
• Dimensions: 940mm x 240mm x 240mm (height, width, depth)

These speakers are made to order and delivery takes around 5 weeks.