Clearaudio Satisfy tonearm

Friction-free gimbal pivot direct-wired tonearm.

Designed for use with a wide range of turntables and cartridges, this award-winning Satisfy incorporates a range of features normally associated with some of the very best tonearms. Designed and built in Germany by Clearaudio Electronic. Build quality and performance are superb.

The arm tube is constructed from aluminium.

The two-piece aluminium headshell with adjustable azimuth allows the accurate alignment of any cartridge type.

The vertical bearing uses a shaft made of Wolfram, the polished ends of which run in sapphire watch bearings.

The twin horizontal bearings use extremely precise and long-life ceramic bearings.

Anti-skating control is applied by an innovative magnetic system that acts on the side of the bearing housing.

An unbroken run of Clearaudio's own Direct Wire cable provides a continuous link without solder connections from the cartridge to the phono plugs.

Length - 296 mm

Pivot to stylus - 222 mm

25mm chassis mounting - machined mount included.

See reviews at http://clearaudio.de/en/_archive/tonearms-satisfy.php

Complete with cartridge alignment gauge and set-up instructions.

Near mint condition - about 300 hours use.

Retail price was $1950.