Features:

Support Micro SD Card, Micro SDHC card (high-speed card)

The level conversion circuit board that can interface level is 5V or 3.3V

Communication interface is a standard SPI interface

Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground,

VCC is the power supply, MISO, MOSI, SCK is the SPI bus, CS is the chip select signal pin;

3.3V regulator circuit: LDO regulator output 3.3V as level converter chip, Micro SD card supply;

Level conversion circuit: Micro SD card into the direction of signals into 3.3V, MicroSD card toward the direction of the control interface MISO signal is also converted to 3.3V, general AVR microcontroller system can read the signal;

Micro SD card connector: yes since the bomb deck for easy card insertion and removal.

Positioning holes: 4 M2 screws positioning hole diameter of 2.2mm, easy to install positioning, to achieve inter-module combination;

Specification:

Power supply:4.5V - 5.5V, 3.3V voltage regulator circuit board

Positioning holes: 4 M2 screws positioning hole diameter of 2.2mm

Control Interface: GND, VCC, MISO, MOSI, SCK, CS

Size:45 x 28mm

Net weight:6g

Geek Studio is a electronic DIY parts store. We are Arduino & Element14 official distributor in NZ. You can find us from Arduino website. You can buy Arduino, Raspberry Pi, Sensors and other 400+ kinds of products from our website. We also provide PCB manufacturing and hardware design services.