Fitted Electric Blanket

Fully fitted non-woven polyester electric blanket

Machine washable

Detachable controls

12 hour timer

Double overheat protection with Sensorsafe technology

2 year warranty

230-240Vac 50Hz

Australia Power Plug

Dimensions (WxDxH) 1800mm (W) x 2030mm (H)

Pre Heat

The controller has a pre-heat facility in order for you to warm your bed prior to getting into it. The time taken to pre-heat the bed will depend on the ambient temperature of the bedroom and whether an electric blanket has been used to air the bed on a regular basis.

At normal ambient temperature you should allow approximately 30 - 60 minutes on Heat Setting 3 (Pre Heat). You may get into bed sooner while the bed is still warming up, but please DO NOT leave the blanket set on the Preheat setting (No. 3) while you are in the bed.

A cold room or bed that has not been used for some time may require a greater length of time on the pre-heat.

Overheat / Element Protection

The blanket is fitted with numerous overheat safeguard systems. This offers protection against overheating or damage to the elements by disengaging the power to the elements before overheating hazards occur.

Should there ever be a problem with the heating element in the Blanket, it will automatically close down the operation and the Blanket will turn off.

The controller must not be covered. The controller has built in protection, so that if the controller overheats, or the heating element is damaged, it will automatically close down the operation Permanently.