LOAD RESISTORS TRADE PRICE (2) for LED INDICATORS

LED INDICATOR LOAD RESISTERS. WE IMPORT DIRECT .

Some motorcycles require these load resistor units to fix the fast flash rate or non flashing when aftermarket LED Indicators are installed and return them to normal rate of approximately 60 flashes per minute.

You will need one resistor for each LED indicator. This listing is for 2 resistors one pair.

Resistor wiring details If you have fitted LED bulbs in place of normal filament type indicator bulbs or stop/tail lights, you may experience fast flashing of the indicators or blown bulb warnings on the ?dash. To cure these problems you will need to fit load resistors across each LED bulb as shown below.

The load resistor has to be connected to the two wires that go to the indicator or tail light bulb holder, one end to the postive (live) wire, the other to the negative (earth) wire. This makes the indicator relay or bulb check circuit see a normal load in the circuit and operate correctly Please note that resistors can get hot during use, do not mount them on plastic.