30 watt 100V/4 ohm PA Amplifier.

Also look at our 100 volt line speaker listings which go with this amplifier.

It also features extensive protection from short-circuit, overload and high temp, and comes with a 3 year factory warranty so you can specify and use this amplifier with confidence.

The basic public address mixer amplifier has a power rating of 30W.
It is a fully featured high quality amplifier with 3 balanced microphone inputs, 2 aux inputs and 2 EMC inputs and suitable for small factory or
warehouse paging systems, reception area and office background music systems, monitor amplifier, library etc

Priority muting is achieved via EMC 1-2 for overriding other inputs except Mic1 on front panel. Individual gain controls are provided for Mic 1-3 and Aux 1-2,
bass and treble controls and master volume control are provided for overall tone control. 70V, 100V and low impedance 4-16ohms speaker outputs are provided. Extensive protection from short-circuit, overload and high temp is also incorporated.

Features
* Mixer amplifier for paging and background music system
* Rated power 30W
* 2U rack mount
* 70V, 100V and low impedance 4-16ohm speaker output
* Three balanced Mic inputs
* Mic 1 (phone jack) with VOX priority and VOX level on front panel
* Mic 2-3 by XLR type on rear panel with phantom power
* Two Aux Inputs and 2 line inputs for spare use
* Two EMC Emergency priority inputs
* EMC1 has priority over all inputs except MIC1
* Mic 1-3, Aux 1-2 and master volume controls and bass/treble tone control
* Short circuit, overload and high temp protection

This is a simple PA Mixer Amplifier, 30W output, with 3 balanced microphone inputs, 2 aux inputs and 2 EMC inputs and priority muting.

Individual gain controls are provided for Mic 1-3 and Aux 1-2, bass and treble controls and master volume control are provided for overall tone control.