This is used in conjuction with the "Lee cutter and lock stud" to trim case to the correct length, this can be purchased separately.

Auction is for one Lee case length gauge & shell holder in one of the following calibres:

Available in:

22 hornet
or 222 Rem or 223 or 223 wssm ** sold out ** or 22-250 or 25-06 or 220 swift or .243 or .243 wssm or 6mm rem/244 rem or 6.8 Rem SPC or 7mm-08 rem or 280 rem /7mm exp or 284 win or 260 rem
or 270 win ** sold out ** or 270 wsm or 7mm rem or 6.5x55 swedish
or .308
or 300 wsm or 30-06
or 30-30 win or 300 win mag or 303 british or 7.62 x 54 R or 338 win mag or 338 federal or 7x57 Mauser or 6.5/284 or 7.62 x 39
or 300 AAC Blackout or 500 S & W or 44 mag

204 (not available) - not manufactured by Lee - direct from lee website "We have no plans in producing a case length gauge in the .204 Ruger. The case mouth diameter is too small for our Cutter to trim. Our Cutter can only trim cases that have a minimum case mouth diameter of .220 inches."

After a case has been loaded a few times, it will stretch beyond maximum length and must be trimmed. There is no better system to check and trim cases than with the Lee case length gauge and cutter. You don't need an expensive caliper to set length and never waste even a single case setting up with the cut and try system common to all other fixed length design assures it will never go out of adjustment.

The cutter and lock stud works for all calibers. You will need only one. The case length gauge (pilot) and shell holder must be ordered as a case length gauge and shell holder for each calibre. You can trim cases by hand, use an electric drill or the Lee Zip trim.

This is used in conjuction with the "Lee cutter and lock stud" to trim case to the correct length, this can be purchased instore.

Case trimmers also available for purchase

Freight $5.50 Nationwide