GS-Cyclone 425 3D brushless electric heli, as new.

1 x Savox Digital Coreless SH-1290MG tail servo

Hitec HG-5000 Gyro, with programming instructions.

3 x Hitec HS-485HB servos

Hyperion CX G3 4S / 14.8v 25C 2500mAh battery pack

Lightweight double aluminium side frames
Brushless motor
Electronic speed controller pre-installed
High performance tooth belt tail drive system
Painted fibre glass canopy
Fully ball-raced
Blade holder

3 x 425mm glass blade sets.

Cyclone 425 Manual

Trainer feet

Spare new belt and some other spare bits for rotor head.

Bought this to dip my toe in the heli pond but have decided I would rather stick to fixed-wings.

This has never been flown. There are some very small nicks to the tail rotor blades from when I started it up on the floor in my dining room a little too close to the wall. They are so minor they do not appear to affect it at all.

Cheap gear for someone wanting to have a go at an electric heli.

No receiver included.

Here's a link to one of these being flown :-

www.youtube.com/watch?v=8TA0q9K6ke4

Pickup only.