Package Included

• 1pcs x Arduino Uno R3
• 1pcs x cnc shield v3
• 4pcs x A4988
• 4pcs x Heatsink

CNC Shield Board:

• Latest CNC Shield Version 3.0 for Arduino.
• GRBL 0.9 compatible. (Open source firmware that runs on a UNO for Arduino that turns G-code commands into stepper signals)
  • PWM Spindle and direction pins 4-Axis support (X, Y, Z, A-Can duplicate X, Y, Z or do a full 4th axis with custom firmware using pins D12 and D13)
  • 2 x End stops for each axis (6 in total) Coolant enable
  • Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping )
  • Runs on 12-36V DC. (At the moment only the DRV8825 drivers can handle up to 36V so please consider the - operation voltage when powering the board.)

Reference

• http://bit.ly/How-To-Control-Stepper-Motor-with-A4988
  • http://bit.ly/A4988-Stepper-Motor-Driver-Carrier

#BP1016

=> ALL PRODUCTS WE ARE SELLING ARE IN STOCK IN NZ <=

If you want to see all the products we are selling, please refer the following link http://www.trademe.co.nz/Members/Listings.aspx?member=6033450

Delivery Note :

• As following our policy, all products will be shipped by a signature required ticket as the default delivery option.
• If you don't want the signature delivery, please leave a comment and specific delivery instruction.

For more information, refer the Q&A section on the listing.

We will provide technical advice for all the products we are selling :)

ePartners