Waste oil burner unit we have tested with excellent results. Clean burning good amount of flame and doesn't cost anything to operate as it's burning waste car engine oil. The idea behind it was so there is no charcoal, ash, or soot in the pot to build up to limit the time you can run the burner for. I ran it for half a day to test this and no charcoal built up inside the pot. So that worked out well. The smoke in the video was the stickers and labels burning off the pot. There was no smoke from the oil.

The fire was large and impressive, and very hot, it was going to be fitted inside a 45 kg cylinder however we have other burner units we are currently fitting into cylinders so this one is currently spare.

It can be seen going on YouTube.com the link to it is below. https://www.youtube.com/watch?v=TEe1pZNvmyk

We built this with the idea of heating larger swimming pools, so copper coils would be needed to be built to transfer the heat into the water, a pump & an enclose cylinder or alike would also be required.

The auction is for the above burner unit and a waste oil controller unit to control the fire. The controller has a dual timer which delivers a set about of oil to the burner and doesn't alter whether the oil is cold or warm and a thermostat fitted should the flame ever die out because of coolant or water in the oil the thermostat will turn off the pump if the fire drops below a set temperature. This stops the oil flow & pump so the back yard doesn't get covered in waste oil.

Comes with a fan for correct air flow to burn waste oil cleanly, also a digital speed controller, and knob to adjust the fan speed to the right speed.