Listing is for a JTEDCC-BF DCC Controller Module with Back and Forth (Shuttle) Control as in the photo. Also comes with a 300mm USB-A to USB-B cable.

Datasheet with more details can be downloaded from: http://www.JTElectronics.co.nz/quicklink/JTEDCC-BF.htm or google JTEDCC-BF

We have advanced the original DCC++ controller configuration to this upgraded model, the JTEDCC-BF which gives automatic back and forth (shuttle) control for up to two locomotives. Once the JTEDCC-BF module is connected to your mainline track and you attach a sensor near each end of the track, the DCC enabled locomotive will travel back and forth automatically under DCC control. The JTEDCC-BF can even control two DCC enabled locomotives on separate back and forth tracks!

It will operate as a back and forth DCC controller totally standalone or can be connected to your computer via a USB cable to configure the back and forth locomotive settings eg. locomotive DCC addresses and speeds. If the JTEDCC-BF module is connected to a power supply, your track(s), and your computer you can use the JMRI software program your DCC Decoders (CV’s) and to run trains on the track like a normal layout.

Also, you can setup the computer as a JMRI network server and control your DCC layout over WiFi from a phone or tablet. Since the JTEDCC-BF controller also incorporates all of the original fully functional JTEDCC Base Station controller, you can still use it to program CV values into the locomotive DCC decoders on a separate programming track! You can use Google and/or YouTube for instructions on how to do this…

Datasheet with details can be downloaded from: http://www.JTElectronics.co.nz/quicklink/JTEDCC-BF.htm or google JTEDCC-BF