Car Paintless Dent Removal DIY Kit, Pops a Dent Bridge Dent Puller
When your car is suffered from dents that can repair a car's dent by yourself, no need to go to the body repair shop spend expensive costs, you can save a lot of money.
PAINT FRIENDLY - The rubber feet on the lifter button prevent paint scratches. The glue will by easily removed if you spray alcohol on it(Glue Stick not included). This car dent removal kit is car paint friendly.
EASY TO OPERATE - Simply tighten the nut in the middle of the nut that effectively repair the car dent. You can quickly get your car back to its original state. Save a lot of time and cost for you.
SPECIAL DESIGN - The unique bridge design eliminates the opportunity for additional damage. Upgraded version of the knob, thicker glue puller, more durable and better for car repair.
WIDE APPLICATION - It can repair different size of the dent without damaging the original paint of the car. It not only can repair all kinds of car dent remover, but also can repair refrigerator, washing machine, motorcycle dent and so on. This is really a useful repair tool.
How to use:
1.Clean damage surface with a clean cloth
2. Put the glue sticks to gun and pre-heat glue gun for 3-5 minutes
3. Match the glue pad with size of dent ,large dents require the large pad .
4. Apply a generous amount of hot glue from the hot glue gun on the selected pad covering the entire surface of the pad. Be sure all 4 holes are covered .
5. Immediately place pad in the center of the dent and hold until it sticks by itself,wait approximately 3-5minutes. The glue should be firm.
6. Place the stem of the pad through the hole in the pops a dent pulling bridge and screw on the knob. Tighten the knob until the pad pops off.
7. Repeat process until dent is level with surface.
8. In the unlikely event that glue stays on metal surface, please use isopropyl alcohol to remove all glue .
Packing List: 1 X Bridge Dent Puller 5 X Glue Tabs 1 X White Tap Down Pen
Note: Glue stick and Glue Gun not included