8gal/min 2 stage pump

brand: WX-XIEHE, well know and widely used brand.

KIT includes
A) one PUMP B) pair of FLANGE PLATES to easily build BELL HOUSING, but not the flat steel pieces needed C) coupling L095 (all 3 pieces) for 3/4 inch motor shaft diameter (1" is available at same price in another auction)

PUMP DATA: the 8 gpm pump is best suited for a 6-8 hp motor and smaller rams.

2 stage makes for high spped at low pressure and high force at high pressure. model 6.3/2.1 dimension drawings and spec sheet attached

FLANGE PLATES DATA: drawings attached, pump side plate has 4 m8 threaded holes to mount the pump, engine side has standard 4 hole mounts suitable for most engines, drawing attached. The purple and blue CG shows a complete assembly: Cut to length and weld 3 flat steel strips 30mm wide x 5mm thick (not supplied)

COUPLING DATA: 1/2 inch for the pump side, 3/4" for the engine side, standard L095 with six leg rubber spider.

OTHER THINGS IN STORE; check out the other things we have to offer:

11gpm, 22gpm we have good quality valves we can make hoses as needed, and supply fittings at very competitive prices

we also stock tractor PTO driven pumps, both tractor mounted directly on the PTO stub, and equipment mounted for use with PTO shaft.

for contact info, warranty statement etc click on "about store" below or paste this link to the browser:

https://www.trademe.co.nz/stores/extrusion-engineering-limited/about-the-store

free shipping applies to north island and south island street address, no POBox no waiheke, no great barrier or any other island