Diesel fuel water separator filter for generator or engine DAHL200 top brand

Recommended Flow Rate= 150lph (Max. = 250lph) Fits: Most diesel engines for example 8 Cylinder Cummins Perfect for smaller engines too,I use on 80hp 4-cylinder Ford. When fitting a water/sludge separator the bigger the better so this is also ideal for small boat engines. You wont get a stalled engine due to bugs in fuel and can easily see and drain contaminants from the large clear bowl.

This filter unit is used as a Pre-Filter to separate water and contaminates thus avoiding costly repairs due to poor fuel quality.

Certification:ISO9001

THREE STAGE FILTRATION

Stage One - Water Separation: fuel enters the filter assembly, it moves through the centrifuge and spins off large solids and water droplets, which fall to the bottom of the collection bowl. Stage Two - Coalescing: water droplets bead-up on the surface of the conical baffle and cartridge element. Then fall to the bottom of the bowl. Stage Three - Filtration: The replaceable HydroShield filter cartridge stops and captures fine hard and soft contaminants, while remaining water coalesces on the media surface. Then drops down into the clear collection bowl.

The DAHL system eliminates water from fuel before reaching the fuel pump and injectors. This prevents the major cause of diesel fuel injection system failure. Many existing fuel filters aren't designed to remove large amounts of water. and only use one step. This means they must be porous enough to allow sufficient flow volume which limits filtering ability. The DAHL system takes care of those shortcomings. DAHL's functional dual-chamber 3-stage diesel fuel filter/water separators provide efficient suction side water separation and contaminant filtration. The key is the unique DAHL patented depressurizer cone which spreads the flow of the fuel. With more area to flow over, greater separation of water and dirt from the fuel is achieved.