Listing Detail Tabs
This is ex DSE stock "Move" brand.
As shown, the cable has both a Mini and a Micro USB plug, that's why I'm calling it a dual cable, you don't get two cables :-) The "native" plug is Mini USB, and it has an adaptor attached to change it into Micro USB.
What more can I say about this. It's 70cm length. I have characterised these personally and would say they are up to the job for about 1.5 to 2 Amp charging current max. I don't have any capability to characterise their maximum data transfer rates, they probably don't have much shielding so it would be OK for low speed syncing, but probably not much good for a USB hard drive or whatever.
For those who are interested, I tested the cable drawing 2 Amps with a 5v supply and the voltage measured at the end of the cable was about 4.42v which is just inside the USB tolerance. It gave a drop on each leg of about 0.3V and therefore a resistance of 0.15 Ohms for the power wires. The data wires will be much thinner and have a higher resistance, which is fine for data.
So in short, I determine that these are fairly decent cables for modest USB Mini and Micro charging, syncing, Arduino communications, and that sort of jiggery pokery.
See all my current listings:
[ usb-mini-micro-cable ]