This listing closed and did not sell. The item has been relisted.
- Browse for similar listings in Other
- View the relisted item
Other listings you might like
Description
- These pliers punch a 1.5mm hole in metal sheet stock up to 20 gauge. They create a smooth, clean hole without barbs or rough edges. Plus, with the gauge guard, the area around the hole will be free of unsightly indentations!
- Instructions for using the gauge guard:
- Hold the pliers shut. When properly adjusted, there should be enough space to insert your metal piece between the widest part of the pin and the bottom jaw of the pliers with a little extra room left over. If the metal doesn't fit or if there's no extra space, simply expand the jaw opening a little farther by turning the gauge guard screw to the right. (Turn right for heavier gauges and left for lighter gauges.)
- NOTE: If the adjustment screw is not properly set, you may cause damage to your pliers due to extra stress and tension on the plier jaws.
- Measurements: 6" long and 2.25" wide at the handle. The hole punch is 1.5mm in diameter and will go through 20 gauge wire or thinner.
- Includes one bonus replacement pin.
- Quantity: 1 BeadSmith 1.5mm metal hole punch plier
- This item is shipped from the USA and expected delivery is 8-10 days.
Details
Condition:
Shipping & pick-up options
Destination & description | Price | |
---|---|---|
First-Class International | 8-10 Days | $6.90 | |
Shipping more than one item | No extra charge |
Pick-ups not available
GST included.
Payment Options
Pay instantly by card, Ping balance or saved bank account.
Questions & Answers
No questions have been asked!
BeadSmith Metal Hole Punch Pliers For Sheet Metal
Closing...
beadaholique1 profile image
beadaholique1 ( 4759 )99.1% positive feedback Seller located in United States
About the seller
beadaholique1
99.1% positive feedback( 4759 address verified in trade
Location
Member since
View seller's other listings