Sat Dish DIY kit includes

• Sat dish with mount and stays
• LNB plus weatherproof boot
• 10 metres RG6 coax
• F connectors and weatherproof boot

Cable is available in black or white - if you do not specify colour, I will send black. I will fit the connector and weatherproof boot for the LNB end and prepare the other end for you to fit after you have run the cable.

Dish Details: Heavy gauge steel reflector 0.7mm -with coatings about 0.9mm Diameter 100cm x 90cm Ku band 1 x curved wall mount 2 x stays 1 x LNB holder (fits standard 40mm LNB) Hardware Assembly Instructions Galvanised treated steel Polyester powder spray plastics finish Light grey No Logos

LNB Details Ku Band Digital LNB Suited for Optus D1, C1, D2 etc.. Freeview / Sky / Ethnic and religious channels etc... Input frequency 11.7-12.75Ghz Output Frequency 950-2000Mhz L.O. Freq 10.750 (same as sky use) Polarisation: H (16-20V) or V (10-14.5V) Single Output Conversion Gain 65dB DC Power 10-20V 125mA

Cable Details: Top Quality RG6 Coax Cable for use with Terrestrial installations (45-800Mhz) and Satellite installations (950-2150Mhz)

Please note - the wall mount supplied will not cater for all installation options. See my range of hot dip galv satellite mounts

• all LNBs are tested prior to despatch. Only connect F plug finger tight. Use of tools may damage LNB
• technical assistance may be required
• for Installations in corrosive locations, check out my azure shine dish auctions
• LNB outer case may differ from picture depending on stock