Noted:This Auntion Listing Diameter is 10cm ,if need 15cm and 20cm,check below link or email us for new auction.

Specification: Name:3D printing touch moon light Materials:PLA plastic Color temperature: 3000K / 6000K(White/Warm White) Battery capacity:500MAH Charging time: 6 - 8 hours Working time: 8-10ours ( depends on brightness ) Charging mode:USB DC5V Charging current:1A Using environmrnt:0-40<75%

Features: 1.3D printing technology: print layer by layer, restore the real appearance of the moon 2.Charging port and switch integration: simple, beautiful and practical, easy to operate 3.Warm and gentle LED lights: touch the metal ring to switch the color and turn off the light 4.You can hold it on your hand. Easy to put anywhere you like with the wood holder 5.Safe and environmentally friendly: PLA material extracted from corn stalks, hard and smooth, non-toxic, odorless, environmentally friendly

Operation:

1. Touch the metal ring at the bottom of the moon lamp to turn on / off the light and change color from white to yellow.
2. Long press the metal ring to adjust the brightness, and it has the brightness memory function.
3. If your hand is too dry or the temperature is too low, the light may not respond.
4. The white light will not shine when power is low.
5. Insert the DC connector into the metal ring at the bottom of the moon lamp to charge, the red light is always on during the charging.
6. The red light will automatically turn off when fully charged.

Notice: 1.When charging,the ball becomes red,full,and then extinguished; 2.Because the installation of the circuit required,the sphere edge will have seam(as shown). 3.3D priting forming principle causes the object surface to have the contour line phenomenon. 4.This product does not have waterproof ability,not strong acid,alkali. 5.This product can not be strongly hit or fall from high places.

Package: 1 Moon light 1 Charging line 1 Product description 1 Wood frame