This listing closed and did not sell. The item has been relisted.
- Browse for similar listings in Paint
- View the relisted item
Mould release wax 125ml
Description
THIS AUCTION IS FOR A 125ML SIZE ONLY
PRODUCT DESCRIPTION Release Wax is a soft general purpose wax for industrial application and on moulds. An exceptionally easy wax to use. Release Wax has been specifically formulated for use in the reinforced fibreglass market. APPLICATION Use a clean soft cheese cloth in a circular motion with overlapping strokes to apply the wax to the mould surface. Leave Release Wax on the mould for approximately one hour at 20 degrees C, longer periods may cause a wax film which is hard to remove. Use it clean polishing cloth on the mould surface moving in a circular motion until all excess wax is removed leaving a bright shine - swirl marks and finger prints should not be evident after polishing. Two cloths may he required, one to remove excess wax, the other for polishing. Apply 5-6 coats of wax leaving 10-20 minutes drying time between each coat Allow two hours after the final coat before applying PVA release agent. SUPPLIED In the following sizes: 125 ml, 500ml, 1L. SAFETY PRECAUTIONS: Do not use near fire or flames. Harmful or fatal if swallowed Use disposable gloves to avoid skin contamination. If resin comes into contact with skin, wash uncured resin off with soap and water. Wear safety glasses to avoid eye contamination. Mixed formulation contains Epoxy Resin and Amines. If swallowed do not induce vomiting. Give a glass of water. Contact a Doctor or the Poisons National Information Centre on 0800 764 766 (Urgent information only). Eye Contamination: Hold eyes open and flood with water for at least 15 minutes. See a Doctor