Honda crf 250r 2009

Time too fund new things so the bike is going. Bought the bike with 8 hours on a full top and bottom rebuild about 15 hours later it dropped a valve bent the conrod and destroyed the head and bore so the motor was completely stripped and every part has been cleaned in a solvent tank. It has a crankworxs aftermarket crank and was sent to Doug engineering to be rebuilt and balanced with a new crankworxs forged conrod and bearing, a low hour second hand bore and complete head were sourced the bore was decked and then honed for new rings at franklin engineering the head was stripped,inspected and decked, the valves were lapped into the seats new valve stem seals and clearances set at factory spec, new CP lightweight Hi Comp piston with rings gapped according to specs supplied by CP pistons. Transmission gearsets were stripped cleaned inspected, polished and reassembled with one new genuine honda thrust washer that was missing. Balance shaft, oil pump, kickstarter assembly, shifter assembly etc all got the same treatment stripped, cleaned, inspected, reassembled has a full hinson clutch that is in excellent condition no wear on the hub or basket and the plates have heaps of meat on them, new water pump seals and bearing new crankshaft spigot seal all new gaskets new sparkplug etc has been run in on semi synthetic oil and now runs motul 300v. New front disk break and comes with some extra bits and bobs. Only down side I’m aware of is slight leak in one of the front forks. Have plenty pics from the rebuild I can supply if genuinely interested. Viewing in Hibiscus Coast.