This listing closed and did not sell. The item has been relisted.

Browse for similar listings in Rack gear
View the relisted item

Other listings you might like

Description

110mm x 101mm x 11mm This is a standard heavy-duty twist latch. This is a two-piece dish assembly and requires extra cuts to the tongue & groove, or hybrid, extrusions for installation. Both recessed dishes have offsets to accommodate the tongue & groove, or hybrid, extrusions.

Rivets Required For Installation: 10

Six of the rivets require backing washers, or a backplate, as those rivets will install through bare wood internally. Two of the side rivets install through the aluminum tongue & groove, or hybrid, extrusions and therefore require no backing washers.

THIS ITEM REQUIRES TWO CUTOUTS IN THE CASE WALLS TO INSTALL THE SPLIT DISH ASSEMBLY.

RECOMMENDED USES: Small To Medium Cases Thin Profile Cases

MAXIMUM RECOMMENDED CASE DIMENSIONS: 20"(50.80cm) Wide and 12"(30.48cm) Tall

NOTE: May be used as a secondary latch on large cases that have removable lids, hinged access doors, or other removable panels.

EXAMPLES AS PRIMARY LATCH EXAMPLES AS SECONDARY LATCH