Listing Detail Tabs
1 x Gunworks standard rear hex suppressor bush bored to 16.8mm
Lightweight Green polymer spanner is 6mm thick
Green spanner is for removing the delrin bush from a Gunworks Suppressor when you have 1 suppressor for 2 rifles and you need to remove the bush in the rear to put in a different sized one.
This doesn't mark the back of the suppressor like a cresent will, and also allows minor adjustment of the bush fit but screwing it in tighter to reduce the hole diameter slightly.
Delrin bush with spanner flat edges
How do I find out what diameter I need my bush bored out to?
Easy, put your Gunworks suppressor onto your threaded rifle (rifle must be threaded to get an accurate reading) and screw the suppressor on until it is nice and tight on the barrel.
Use verniers to measure the diameter of the barrel where the suppressor finishes (see pics) you can place a vivid pen mark at the same spot and remove the suppressor to take the reading if you wish.
Will combine freight where I can. Police Mail Order Form not required for purchasing projectiles, cases, primers or powder.
Because of our low competitive prices we are not in a position to offer free freight.
SHOP IS CLOSED BETWEEN 12PM FRIDAY 22ND DECEMBER 2017 & SUNDAY 14 JANUARY 2018 ** SO NO PICK UPS SORRY DURING THIS TIME **, BUT I WILL BE DISPATCHING TRADEME & WEBSITE GOODS BY COURIER EVERY WORKING DAY.