J-B WELD - DON'T SCRAP IT - J-B WELD IT

J-B Weld max temperature tolerance is 600 degrees F

J-B Weld tensile strength is 3960 PSI

J-B Weld does not conduct electricity

J-B Weld cure time is approximately 15 - 18 hours.

J-B Weld consists of two parts. Squeeze equal parts from each tube onto any clean disposable surface. Mix together thoroughly.

Surface for application must be clean, dry and free from dirt, grease, oil etc. before applying J-B Weld. For the best weld, roughen surface to be J-B welded with a file or coarse sandpaper.

"Used J-B Weld on a cracked gear-case on a 90 hp outboard, tested it today - Went 11 ks off West Coast in rough seas. Guess what - it passed with flying colours! What a product, was told $4000 plus labour to fix it. Many thanks Geoff.

"JB Weld is damn good stuff! Used it to attach sky aerial to roof of my motorhome, there is no way it will move!

Maybe you might want to check on the feedbacks from many and various J-B users - you will have a use for 'on the run' permanent repairs'. Happy chappies are on my feedbacks.

Please refer to my other listings for further products in the J-B range that may suit your application.

STOP PRESS....NEW PRODUCTS.....

J-B Plastic Weld for repairs to car bumpers, RC cars etc.

J-B Kwik Wood - fill and repair wet rot, dry rot, boats, caravans, house buses, yachts - sandable, paintable, no shrinkage.

J-B Threadlocker - medium and high strength - costs less than Loctite!

Enquire through this action.

Reseller enquiries welcome - have I got a deal for you!