Boc mig welder, 150c model, fantastic little welder, have had for around 18 years, did a lot over first eight or so then upgraded and it has done very little since then, fired it up to check it out an it works well in every way, played on 3, 6 and 10mm stock. Built like a brick shit house and weighs a lot as it’s full of copper and goodies instead of circuit boards (it does weigh though so not at easy to swing around a job site like new ones). 150amp. Adjustable polarity to suit gasless wire. Binzel torch. 15a plug but it bits in to a 10a socket. No earth lead sorry. Two extra rollers. A few extra tips and parts Rollers 0.6mm 0.8mm 1.0mm (mild steel wire) and 0.9mm and 1mm knurled for flux cored wire. Extra liner. A few rolls of wire, x1 0.6mm mild - in machine, x1 0.6mm mild - new in box, x3 different rolls of 0.9mm gasless flux cored, x1 small 0.8mm flux cored gasless, x1 0.8mm mild steel pretty much full. Stand/trolly in photos is included if you want, it’s a bit wiggly but better than nothing. Good welder has been used on things from 0.8-1.0mm panel steel, lots of 3-5mm box, flat, angle etc, and on bigger stuff 10mm sometimes more. Welcome to view Pickup 5mins north of Timaru