Brand New Free Replacement - Tempercon Ltd

Tempercon (NZ) Ltd specialises in Digital Water Heat Pump Controls.

F11-Setting temperature, F12-Temperature differential controls 0.1~20C, F31-Solar heater low temperature set-point to switch off circulating pump, F32- Solar heater high temperature set-point to switch on circulating pump.

It begins to heat output when the temperature is under "F11-F12", controller will auto switch on circulating pump when solar sensor temperature is above F32 and switch off circulating pump when solar sensor temperature is below F31 , and stops heating when the temperature is reaching "F11".

Controller heat output to be connected with Gas-heater, Electrical-heater or other heating system, also heat output can be used for By-pass controlling. You do not need connect wire to heat output if you have solar heater only. Controller pump output to be connected with circulating pump Contactor coil or Relay coil and water solenoid valve.

Specifications:

Display: 4 Digit LED Display Temperature Sensor Type: NTC Sensor: NTC Probe Output: Relay (250Vac 8A Resistive) Temperature Unit: C or F Temperature Range: -50C150C or -58F302F Differential(Hysteresis):0.1C20C or 0.1F20F Resolution: 0.1C or 0.1F Accuracy: 0.5C Power Supply: 230Vac 50HZ Operating Environment: Temperature -20C ~50C, Humidity<85% Waterproof Panel Mounting: IP65 Rectangular Panel Mounting: 71mm X 29 mm

This auction (TC33-8023) has 2 NTC sensor probes with 2 meters cable for free charge. Extra Sensor Probe Options:

1. NTC sensor probe with 2 meters cable price $10.00/Each.
2. NTC sensor probe with 5 meters cable price $14.50/Each.
3. NTC sensor probe with 10 meters cable price $22.00/Each.