PLEASE NOTE PICKUP IS IN MATAMATA!

Teknatool TL1000 8S

8 speed 1hp single phase motor 1m long bed 320mm swing over bed 500mm swing outboard Indexable 2 Teknatool Scroll Chucks with 50mm jaws ( 1 is left hand thread for outboard, I have the right hand insert here somewhere) 1 set pin jaws 1 set Cole jaws 1 Jacobs chuck Good steady table 3 Tool rests 2 spur drives Face plate misc bits and bobs, face plate ring a few bits of wood to get you started

I have owned this great lathe for about 3 years now and am now ready to upgrade to something newer. Have turned some large pieces on the outboard setup.

Will throw in a nearly new 8in Makita double ended grinder if BUY NOW is used, with tool sharpening wheel, mounting board and slide for tool sharpening. It is missing the toolholder but these are readily available.

LAST RELIST, WILL WITH ME WHEN I MOVE PICKUP IS IN MATAMATA