Description The MPU-9250 is a 9-axis MotionTracking device that combines a 3-axis gyroscope, 3-axis accelerometer, 3-axis magnetometer and a Digital Motion Processor™ (DMP) all in a small 3x3x1mm package available as a pin-compatible upgrade from the MPU-6515. With its dedicated I2C sensor bus, the MPU-9250 directly provides complete 9-axis MotionFusion™ output. The MPU-9250 MotionTracking device, with its 9-axis integration, on-chip MotionFusion™, and run-time calibration firmware, enables manufacturers to eliminate the costly and complex selection, qualification, and system level integration of discrete devices, guaranteeing optimal motion performance for consumers. MPU-9250 is also designed to interface with multiple non-inertial digital sensors, such as pressure sensors, on its auxiliary I2C port.

Features Three 16-bit analog-to-digital converters (ADCs) for digitizing the gyroscope outputs Three 16-bit ADCs for digitizing the accelerometer outputs Three 16-bit ADCs for digitizing the magnetometer outputs Gyroscope full-scale range of ±250, ±500, ±1000, and ±2000°/sec (dps) Accelerometer full-scale range of ±2g, ±4g, ±8g, and ±16g Magnetometer full-scale range of ±4800µT I2C and SPI serial interfaces Power supply: 3-5v

Applications TouchAnywhere™ technology (for “no touch” UI Application Control/Navigation) MotionCommand™ technology (for Gesture Short-cuts) Motion-enabled game and application framework Location based services, points of interest, and dead reckoning Handset and portable gaming Motion-based game controllers 3D remote controls for Internet connected DTVs and set top boxes, 3D mice Wearable sensors for health, fitness and sports

GeekStudio is an electronic DIY parts store. We sell Arduino, Raspberry Pi, Sensors and other 400+ hardware. Visit our website for more details.
PO Box address is not supported.