Product Details:

• New Rotary Coaxial Cable Stripper(2-Blades Model) for RG-58(3C2V), RG-59/62, RG6...
• 100% New, Top Quality
• Complete Stripping in just a few turns, nothing else special required. Strip in seconds! Dual blade system. One blade strips the outer insulation. The second blade strips the inner dielectric insulator down to the center copper electrode. Lightweight ergonomic design. Fully adjustable 2 blade design lasts for hundreds of coax cuts.
• Can be used for RG-59, RG-59 Quad, RG-6, RG-6 Quad, and RG-58.
• Stripping Length: This stripper can stip cable in four lengths 4,6,8, and 12mm. The stripping length is preset to 6mm. If you want to strip other lengths, you may adjust the blade's position.
• Blades' Depth: you may use the hex wrench, which is install on the bottom of the tool to adjust the blades' depth. Insert the hex wrench into the blade depth adjuster on the bottom of the stripper, then rotate the hex wrench clockwise(to cut smaller cable) or counterclockwise(to cut larger cable). Repeat above steps to set the other blade.
• Stripping cable:

1. The V-block is reversible. Use hex wrench to push the V-block out of the housing, align the character on the V-block with thearrow, then insert the V-block into its housing. The indicated arrow. -recommended the RG cable size mark in front of the V-block. 6=RG6(4C2V), 8=RG58(3C2V), 9=RG59/62 D=RG-174(for HT-332D).
2. Press the knurled portion on the upper jaw to open the stripper's jaws.
3. Insert the cable you want to strip through the V-block until the cable reaches the V-shaped cable guide. Then release the upper jaw to close the jaws.
4. Insert your index finger into the stripper's finger ring, turn the stripper clockwise 1-4 times. The cable's insulation is cut while you turn the stripper. 5 Open the jaws and remove the cable. Pull away the outer jacket and dieelectric to expose the inner conductor.

• No replacement casette is needed
• Accessory ONLY. Package Included:
• 1 x Cable Stripper