PWM Solar Controller - 6V/12V/24V 10A

This product can automatically manage the work of solar panel and battery in solar system. It is widely used in solar system for gardens, pools, roads, stages, etc. Only applicable to solar power, rated voltage of 6V/12V/24V systems, gel batteries, liquid openings or sealed lead-acid batteries.  

NOTE: Keep ventilation. Keep away from children.   Use the insulated tools while operating the controller.              Keep the batteries from the short circuit under any circumstances, we strongly recommend connecting the batteries with the fuse.

FEATURES:

• Use the battery discharge rate characteristics to correct discharge control
• The series connection PWM circuit is implemented to form the major charging
• Make the voltage loss half of or lower than the diode charging circuit, and the charging efficiency 3%-6% higher than the non-PWM
• Three operating modes can be selected: normally open mode, the pure light control mode and light control plus timing mode

          Method of Operation:

1. Firstly, determine the controller output mode , the device factory default setting is normally open mode. If you need to set for the pure light control mode or light control plus timing mode, you need to open the enclosure through set dip switch, changing the discharge mode.
2. When the key set "on" is 1, the key set "off" is 0, normally open, pure light control.
3. Connecting the battery. If correctly connected, battery indicator will light up.
4. Connecting the wire of the solar panel second. If the connection is correct, the indicator light of“charge”will be on or flash 10 seconds later after laying outside under the sun. Otherwise, please check the connection, making sure the solar energy panel is laid outdoors under the sunshine.
5. Connecting the load at the end. If inversely connected, the led lamp may be damaged.
6. Please pay attention to the anode and the cathode to avoid the inverse connection.

PACKAGE CONTENTS: 1x Solar Controller 1x Manual