See my other items to combine shipping, see my current specials, and new products: http://mytrademe.info/

This is a "dent-n-ding" knob, that means it has some sort of minor damage to it and so out it goes cheap. Picture is of a knob, not the one you will get in particular, the one pictured has about the worst condition, as you can see even the worst condition isn't too bad.

Generally the damage is minor scratches or small dings on the top surface of the knob suffered during shipping. They are only cosmetic.

If you are energetic you could sand and buff the top (800 grit or higher followed by good-old toothpaste will get you most of the way), or paint them, or just use them as is if you are lazy like me and just want a knob that turns.

Plastic core, aluminium shell, approx 23mm wide, 17mm high.

Standard 6mm round shaft size.

You can fit ribbed type shafts or D type. Using a D type shaft you might need to knock back the ribs in the hole slightly (just use a drill bit with your fingers, or even a screw driver's blade) to make the fit a bit easier otherwise it's pretty tight.

Very nice appearance, and the mid-size diameter makes it good for course or, or fine tuning. If you want to do more of a jog type dialing then you might want to check my other listings for the 40mm knob, or the special jog dial flat knob.

See my other knobs in various sizes: http://mytrademe.info/bb-knob

Rotary encoders too: http://mytrademe.info/bb-encoder

[ knob-23mm-silver-dent-n-ding ]