You can now shop online with Gunworks, check it out!!

Black Aluminium Why do we like this model of Talley rings? Lightness & rigidity, the one piece base with the lower ring incorperated means nothing to come loose under recoil, knocks or vibration in a vehicle, we see many rifles where scopes have loosened as a result of those factors.

Weight is important these days, we spend a lot of our gunsmithing time reducing rifle weight, fibreglass stocks, alu bolt shrouds, bolt knobs & barrel fluting & space age materials in sound suppressors, we don't see the need for heavy steel rings given that the scope tube is light ali anyway in most cases.

Fitting, we recomend 2 pot epoxy (hi strength araldite) to glue the base part to the reciever & tap on the screw head during the final tighteneing phase to bed the screw down.

Measurements are taken Top of the receiver to the bottom of the scope tube & are approx Auction is for one set of the following:

30mm Kimber 84M

Low #738749 Front Base = 10mm Rear Base = 10mm or

Medium #748749 Front Base = 12mm Rear Base = 12mm

or

High #758749 Front Base = 15mm Rear Base = 15mm

We are often asked "will my XYZ 3-9x40 fit my rifle with these rings?" without seeing it, its very hard to say

However you can work it out yourself by placing the scope above the reciever (on plastisene blocks makes it easier) so the objective bell (the front part of the scope) clears the barrel & the ocular bell (the back part of the scope) clears the bolt handle, flag safety etc)

Then measure the gap (that we are looking for) between the top of the front reciever ring (above where the chamber starts) & the bottom of the scope tube, (which may be 4mm or 16mm etc) which should tie in with the height of the ring in this listing

Freight $4.50 nationwide

Will combine freight where I can. Also even when combining freight price may still increase slightly Note - not all auctions can be combined due to weight and/or size of item.