Forged 3sgte Engine

Rebuilt 3sgte Engine

This engine has not been run since being built. I purchased and had rebuilt by Revolution Automotive Engineering in Timaru at a cost of $4,000 back in 2014.

The engine comes as a front facing setup with:

• Forged Rods
• Forged Pistons
• Reconditioned head
• ACL race bearings
• ARP head Studs
• HKS 3 layer Head Gasket (used but still good)
• Front facing intake with Adaptor plate and throttle body
• Winged/Gated Sump with custom oil pickup
• new water pump etc

The block was pressure tested before being built and also balanced as I wanted to put 500+ hp through this block.

This setup is perfect for a 3sgte RWD setup you could find the right sump, intake and exhaust for a Celica or MR2 build.

I am not sure which generation 3sgte this is, but happy to take any pictures if you would like to see more.

The engine has been in dry storage since being built. I only just took the head and sump off recently for the pictures so you can see the condition. Receipts was lost years ago while I was travelling over seas. There are some marks in the bore where water was spilled however it was cleaned up within a few hours and only caused minor discolouration.

I also have an Borg Warner s256 with 3000km and aftermarket exhaust manifold with t3 flange in my other listing.