Heat Shrink Kit - 560 pieces cut to length

Industrial quality adhesive heat shrink insulation tube

2:1 shrink ratio Heat Shrink Electrical Sealing Insulation Tube to 600 volts

This sale is for one plastic box of cut to length heat shrink cable sleeves.

Shrinkage Ratio:2:1 Final max shrink to 1/2 its original inside diameter size..

Label size column = gives the original unshrunk inside diameter followed by the fully shrunk inside diameter size.

i.e. 1 mm inside diameter shrinks to .5mm inside diameter and so on.

Sizes:
See image (click image to enlarge it)

Colours: red - yellow - blue -green - black - yellow

Total:560 pieces in a plastic box

Operating Temperature:-45C to +125C Minimum Shrinkage Temperature:+70C Full Shrinkage Temperature:+110C-125C

Superior seal for water, gas dust and corrosion resistance.

Ideal for outdoor, marine or industrial use and perfect for vehicle wiring, trailers and mains power wire joins.

• Trade or handyman use
• To shrink - use heat gun on LOW, soldering iron or brief small gas flame.
• Do not overheat. Apply heat briefly right around the circumference until maximum shrink is achieved.
• Shrinking starts about 80C and ends about 105C

Use: Add strength and insulation to electric wire joinsand protect against vibration, flexing, movement or abrasion. Protect small diameter metal or plastic tube where it goes through a bulkhead or might be subject to strain or wear.

Each pack contains a variety of the most useful sizes - please check photos for sizes and quantities. 560 pieces per kit.

See also our 3:1 with adhesive kit and 4:1 adhesive heat shrink incut to size lengths.

If there is a delivery delay please check the Tracking Information you were sent.. For any other issues, please contact us by email. PLEASE include any size, colour, delivery instructions or other options in "Delivery Instructions" - NZ owned and based business - all products shipped from NZ.