Sansui SR-838 in good condition, some light scratch markings on the front from the cat. Moving on as both hardly get used. MCF mass concentrated fulcrum tonearm and up-front controls.

Features include a zinc alloy die-cast tonearm base, direct readout tracking force, headshell tilt adjustment, lockable arm rest, gold plated connection pins, arm height adjustment, lever/weight anti-skate device and oil-damped arm lifter.

Specifications

Power supply: currently a japanese plug, 100V, step down transformer included.

Type: two-speed, quartz-servo, direct-drive, manual turntable

Motor: 20-pole, 30-slot DC brushless type with built-in frequency generator

Drive system: direct spindle drive, quartz servo controlled

Platter: 318mm, 1.7kg, aluminium die-cast

Wow and flutter: less than 0.025% WRMS

Signal to noise ratio: better than 64dB

Speeds: 33 and 45rpm

Fine speed adjustment: +-2.5%

Tonearm: statically balanced, s-shaped tonearm

Effective length: 230mm

Overhang: 16.1mm

Offset angle: 22.5 degrees

Cartridge weight range: 4 to 11g (11 to 20.5g with sub-weight)

Dimensions: 490 x 167 x 390mm

Weight: 12.8kg

4 channel quadraphonic receiver QRX-7500 by Sansui. All knobs and switches are clean and quiet. The wood case is in ok condition, with some additional wear on a couple of corners, easily repairable. The receiver has performed well with the turntable.

Current power supply is via a Japanese plug, 100V, step down transformer included.

Tuning range: FM, MW

Power output: 32W/ch (stereo), 25W/ch into 8O (quadraphonic)

Frequency response: 30Hz to 30kHz

Total harmonic distortion: 0.3%

Damping factor: 40

Input sensitivity: 2.5mV (MM), 100mV (DIN), 100mV (line)

Signal to noise ratio: 70dB (MM), 80dB (line)

Output: 100mV (line), 30mV (DIN)

Speaker load impedance: 4O to 16O

Semiconductors: 159 x transistors, 94 x diodes, 13 x FET, 5 x IC, 9 x zener diodes

Dimensions: 594 x 203 x 370mm

Weight: 21.8kg