Euro connector / block

Convert your welding machine to Euro or replace your existing block. This unit is supplied with an extra long guide tube and we find they fit 99% of machines. This installation can be a little fiddly but if you have a good mechanical aptitude it should be obvious. Most installations are not a direct replacement and will require some machining or at least cutting and filing to get the stem to mount to the drive motor assembly.

The threaded section is M12 x 1.0 and it extends 96mm from the back of the block. The thread starts 36mm from the block. The guide tube will extend 34mm from the thread when it is seated correctly into a torch.

We have two types, one has the gas connection coming out the back the other the side. Let us know which one you want by putting a note in the 'delivery instruction box' when you make payment.

See our other listings for 'Euro adapters' from Miller, Lincoln, Tweco to euro. These unit are complete with the machine remote plug and can be fitted in seconds. ($69.95)

Much of our stock is not listed so question us if you are looking for a specific item or need a custom solution that our technicians can build to your requirement. Existing customers are also able to access our nationwide repair service. Most of our listings have options that can be selected using a drop-down menu found near the top right of this page. If you can not find an item you are looking for question and we will be only too happy to assist. If you would like to see our other listings just search our name Weldingstuff while ensuring you have selected "all categories" from the menu.

GST receipt will be emailed to you.