CUTEK® Quickclean is the perfect way to regularly keep all your wood clean, and it prepares wood to optimize the performance of maintenance coats of CUTEK® Extreme CD50.

It will easily remove dirt, grease and grime from your outside surfaces as well as even out CUTEK® Colourtone that has started to wear or erode unevenly on your wood.

Application:

Dilute the CUTEK® Quickclean concentrate with water as required and complete a test patch to ensure that the dilution being used is effective in cleaning.

Wet your substrate with water prior to applying CUTEK® Quickclean. Apply diluted CUTEK® Quickclean liberally with a brush, roller, lambswool applicator or broom. Let CUTEK® Quickclean do the work by leaving it on the surface for 5 to 15 minutes depending on the severity of dirt/soiling/grease. It may be necessary to scrub stubborn stains moderately with a stiff fibre brush.

Removal:

Once CUTEK® Quickclean has cleaned the substrate, it must be water rinsed off thoroughly. For best results, power rinse methodically with a high-pressure washer set to approximately 50 bar (750 p.s.i.) with a fan jet pattern.

CAUTION must be used when power rinsing to avoid damage to the wood fibre and ‘furring up’. Adjust your cleaning process by reducing the pressure or adjusting your operating distance from the substrate to avoid damage.

Clean from the highest point and work down methodically using long even strokes in the direction of the grain. DO NOT use “turbojets” on timber.

For situations where strong water washing is not practical, wash off with clean water from a bucket or a garden hose using a light scrubbing action with a stiff brush.

Clean-Up:

Equipment may be cleaned with water. Ensure wash water is disposed in accordance with local regulations.

Safety and precautions:

Before you begin to Prepare and Protect your timber, note the hazards and precautions on this label and ensure that you have obtained and know how to use the correct safety equipment. CUTEK® Quickclean is a hazardous