If your Mig welder has 24Volts wire drive motor and Euro connector (most of Mig welders have 24 Volts) use your current Mig welder for professional Aluminium Welding. Complete kit comes with followings. Change over to your excising torch in seconds to do steel welding.

Unlike other trameme auctions, this auction comes with complete kit to convert your compatible MIG welder to use this spool gun.

1. Push Spool Gun with 8M cable
2. Toggle switch to be fitted to your welder (to select your current torch or this push spool gun)
3. 2 pin Socket to be fitted to your welder (24Volt power supply for the Gun)
4. Installation DVD and Instructions for you to do a small modification in order to set this up.
5. Spare Nozzles 4nos.
6. 1.0mm Contact Tips for Aluminium Welding 10 nos.
7. 0.8mm Contact Tips for Aluminum Welding 10 nos.

Additional Nozzles and Contact Tips are available in welding stores as this is similar to Miller parts.

Push Spool Guns are used worldwide by professional Aluminium Mig Welders. Also enjoy 8M cable so that you can keep your welder about 8M away where you weld.

Aluminum MIG Welding Tips

1. The best feeding of wire for aluminum is done with a spool gun. If you cant use a spool gun, use the shortest gun possible and keep the gun as straight as possible. Use Argon only for shielding gas. Only use a push gun technique when welding aluminum.
2. If you are having feeding problems, one thing you can try is a contact tip that is one size bigger than your wire.
3. The most common wire type is ER4043 for all-purpose work. ER5356 is a stiffer wire (easier to feed), and is used when more rigid, higher-strength weld properties are needed.
4. Clean the aluminum before welding, to remove the oxide layer. Use a stainless steel wire brush used only for cleaning aluminum.
5. Fill the crater at the end of the weld to avoid a crack. One way to do this is to dwell in the weld pool for a second at the end of the weld.