1 x Waterproof Clear Cover Plastic Electronic Project Box Enclosure Case 85 x 58 x 33 mm

A great little Waterproof box for putting that next project into, will fit an Arduino with shield and a few other bits, comes with seal strip and screws, I have waterproof cable glands as well to make a fully sealed box. This one has pre drilled mounting tabs at either end to secure from the outside, tabs can be removed if not required.

• High Quality Construction
• Dimensions 85 x 58 x 33 mm
• Heavy gauge extruded plastic construction
• Built-in mounting holes for circuit board
• Excellent waterproof performance
• Good for electronic projects, power supply units, student projects, amplifiers, etc.
• Has four mounting holes one in each corner outside the sealed cavity.

Quantity:1PC

Note! picture is indicative slight variations in colour and design can occur in different batches

project box, plastic box, plastic enclosure, jiffy box, electrical box, meter box, arduino project box, waterproof enclosure, waterproof project box, splashproof box,

We dont mark up on shipping so be assured of the best deal possible, LOWEST prices on product and shipping, combined shipping welcome ! Just pay the highest courier charge of any item and the rest travel for free, any amount! We use CourierPost and deliver to PO boxes All goods located in NZ All goods come with 12 month RTB warranty Thanks