"A" Cat accessory only Please Check My Other Listings

The Listing is for a Small for 223, 222 and 204. This works in both the full polymer "S" and the metal insert "SM" magazines

If you need one for a different calibre, please check my other listings.

Single Round Adapters. These insert on top of the magazine follower, just like putting a round into the magazine. Then you will be able to drop a single round in through the ejection port, and chamber it smoothly.

Great for teaching new shooters & children firearms safety without having to feed from the magazine.

Also great for hand loaders who want to load over the maximum case overall length.

3 sizes available, 1 more I need details on (Short Magnum). Please check the top of your magazine for the size (see photos if you’re unsure)

BUYING WILL NOT TRIGGER REGISTERY

Disclaimer: As with all 3d printing there will be some “flash” this is the extra small bits left on the object during the print. I have taken most of it off, but there may be some left. This can be quickly removed with a knife or fine sandpaper. ABS is hardy and resistant to most chemicals. I’m sure they will see you through many happy years of shooting. A lot will have to do with use and the solvents and oils they might be exposed to. I would recommend avoiding significant contact with both chemicals, getting a bit on the block will be fine, you can always wash them with soap and warm water. I am not expressing or implying any form of warranty and I am not “in trade”. Shipping cost are non-negotiable, as I live rurally and it is 40min to the nearest post shop.