These stylish & trendy Baby Carrier suck pads will protect your Baby Carrier straps from dribble - making them the ideal accessory.

The actual carrier can be difficult to wash & dry & constant dribble can deteriorate the look & the resale value of you Baby carrier.

They are super simple to attach with a full length strip of Velcro strip & easily removable for washings.

(Don’t forget to close the Velcro when placing in the washing machine). Do not iron the Velcro.

Patterned on one side with a contrasting fabric on the other side they are reversible so either side can be facing outwards.

Pattern placement may vary slightly from that shown.

I also make Seat Belt covers, please see my other listings for those.

Made of cotton front & back with a layer of absorbent Flannelette in between.

The fabric has been washed prior to being sewn up so they are ready to use as soon as you receive them.

The hanging loop is made from webbing so is super hard wearing & triple stitched for safety.

You can attach jump rings, a pacifier strap, toy etc. DO NOT hang long items that may become a hazard to a small child especially if they are behind you.

Would fit a Baby Carrier with strap approx. 8.5 – 9 cm across, there is a bit of adjustment available due to the width of the Velcro.

Please note that the ERGO 360 may be better suited to the belt covers I made because they are narrow at the botton.

Keywords: Baby carrier, Suck Pads, Lillebaby, Ergo, Tula, Beco, Manduca.