Rixson full-mortise intermediate pivot hinge create less stress on the frame assembly to help prevent door sagging, maintain door alignment, and allow the door to swing with less resistance. Also reduces the likelihood of fasteners pulling out over time and aids with the installation of floor closers and bottom pivots.â?¢ Right handedâ?¢ Not load-bearingâ?¢ 3/4" (19mm) offsetâ?¢ Door edges must be beveled in 1/8" in 2"â?¢ Includes wood screws and machine screws<ParagraphNotes/>Note: On labeled fire door assemblies, NFPA80 requires an intermediate pivot for every additional 30"(762mm) (or fraction thereof) of door height over 60"(1524mm).

Pivot Hinge, Brass Material, Satin Chrome Finish, 250 lb Load Capacity, With Holes, 5 Holes per Leaf, No Ligature Resistant, 180 Degrees Range of Motion, Orientation Right Hand, 1 3/4 in Required Door Thickness, Bushing Bearing Type, Square Corners, Included Hardware, Full Mortise Mounting, Hardened Steel Pin Material, Nonremovable Pin Type, BHMA/ANSI NO: C07162 Standards, Door Leaf Height 5 in, Door Leaf Width 1 1/8 in, Frame Leaf Height 5 in