Should suit most excavators in the 10-15 tonne class but you'd want to check. We sorta remember it came off either a Komatsu PC120-8 or PC138 model but we've had it in the yard for years waiting until we buy another 12 tonner but yeah na. We haven't

Every detail you need to know to see if it'll fit your hitch are right here along with a few handy hints:

The fixed pins are 60mm diameter but if you don't have a hitch you can knock the pins out and attach it direct to your dipper tip, like old school. If your hitch is for a smaller machine you can take the pins out and take them to a machine shop to take the middle section down to the diameter you need. Width between the ears )where the hitch or dipper tip fits in) is 265mm If your arm is narrower than that you can add some shims to take the side play out.

The spacing between the two pin centres is not so important as long as its within a bull's roar of 375mm

Bucket Width is 1840mm Bucket height is 700mm Bucket dept is 850mm and if you know an Einstein he/she/they/them can work out the cubic capacity of the bucket in case you need to know. I reckon about 0.3m3 but that's only a guess.

This bucket is not new nor even close to being new. If it could talk it would complain about Helen Clarke. If it were a human it'd look like her too. But its not bad, it'd see a farmer out even if he/she/them/they used it for pushing posts.

Its been in our stock for so long no one including the accountants remembers what it cost us but the recent makeover wasn't cheap, invoice provided if you need one .